The mesh carries the pattern
A mesh is a model made of vertices and faces. Choose a ring for a light circle, a flat Plane/Quad for a smoke image, or a strip for a bending ribbon. Decide the shape first, then match its UVs, the image-placement coordinates.
| Shape | Typical use | Check |
|---|---|---|
| Plane / quad | Sparks, smoke, glow cards, ground marks | Edge-on views; billboard orientation comes from rendering/animation, not the plane alone. |
| Ring | Ground shockwaves, ripples, circular markings | Band width, center hole and UV projection. |
| Cone / cylinder | Jets, tornadoes, light columns | Circumferential seam and vertical UV direction. |
| Strip / curved surface | Slashes, trails, streams | Match UVs to travel; a moving trail also needs geometry-generation logic. |
UVs change how the same shape is used
Projecting the ring from above gives UVs suited to a concentric image. To flow a pattern around the ring instead, open it at a seam and arrange the UVs as a strip: U runs around the circumference and V across the band. Choose the UV layout for the motion you want before animating it.
Apply a checker image containing numbers and arrows. Check for stretched numbers, wrong arrow directions and visible seams. A Normal Map fakes small surface bumps through lighting, so also check the imported surface directions when using one.
Choose pivot, face direction and subdivisions deliberately
The pivot is the point around which the mesh rotates and scales. Put it in the center of an expanding ring or at the base of a beam that must stay attached at one end. If the mesh disappears only from behind, inspect face orientation and culling, the setting that decides whether backfaces are drawn. A two-sided preview helps identify a front/back issue.
A mesh needs more vertices in the bending direction to form a smooth curve. UV scrolling only moves the image coordinates, so adding many subdivisions to a flat surface does not help that motion. Check triangles and imported vertex counts when measuring cost: UV seams and differently oriented faces can split vertices during import.
Check before handing the mesh to the engine
- Agree on real scale and compare with a known one-meter object.
- Check applied rotation/scale on an export copy; do not indiscriminately apply Location.
- Verify UVs, face direction, pivot and required vertex colors after import.
- Do not expect Blender material nodes to become equivalent engine shaders.