Separate waiting from blending
An Animator Controller stores animation states, such as idle and walk, and the conditions for switching between them. If SetTrigger does not switch the animation, check the trigger name, transition conditions, blending, and Animator updates. This guide targets Unity 2022.3 LTS. If Timeline or Playables also drives the object, first check which system controls the animation.
1. Inspect the live Animator and parameters
In Play Mode, select the intended Animator and inspect its Controller, layer, current state and Parameters. With multiple prefab instances, make sure code writes to the same Animator you are observing.
Match parameter names and types. Bool or numeric values can represent sustained state; a Trigger can represent a request. SetTrigger activates a parameter rather than directly playing a destination. A Trigger resets when consumed by a transition. Inspect repeated SetTrigger calls and any ResetTrigger call that cancels the request.
2. Inspect Has Exit Time and every Condition
Select the transition arrow, not the state node. With Has Exit Time on, its time gate and every configured Condition must be satisfied. Conditions are combined with AND, not OR. An active Trigger cannot override a false Bool or numeric condition.
Exit Time 0.75 means normalized state time, not 0.75 seconds. In the illustrated simple playback, it corresponds to about 75% progress. Looping exits below one are evaluated each loop; values above one identify a point after a specified number of loops. Do not assume the time gate remains permanently open after passing 0.75 once.
For a transition that should respond without an Exit Time wait, turn Has Exit Time off on that arrow and review its Conditions. Eligibility is evaluated by the Animator; it is not a promise of a synchronous state switch at the SetTrigger statement. Preserve time gates on transitions that intentionally wait, such as an attack's return.
3. Separate duration and interruption
If the transition has started but the result changes slowly, inspect Transition Duration. It controls blending after transition start. Fixed Duration uses seconds; otherwise the duration is a normalized fraction of the source state's duration.
Inspect Any State transitions, competing arrows, Interruption Source and Ordered Interruption. Reduce candidates in a minimal Controller and observe whether the Animator is waiting or choosing another path.
4. Check Animator updates
Inspect disabled GameObjects or Animators, Animator.speed zero and pause logic. Review Update Mode with the intended time source. For offscreen-only failures, inspect Culling Mode: Cull Completely disables animation when renderers are not visible.
Verify the correction
- Observe the requested parameter and current state on the intended instance.
Inspect transition / overlap - Keep the required time gates and verify every Condition.
Inspect transition / overlap - Evaluate transition-start delay separately from blend duration.
Inspect transition / overlap - Check repeated inputs, renewed requests, pausing, offscreen return and the target device.
Inspect transition / overlap
See unscaled time for pausing and the Animator Controller glossary for the basics.